Characterization of 3D Printed Auxetic Sinusoidal Patterns/Nylon Composite Fabrics 


Vol. 21,  No. 6, pp. 1372-1381, Jun.  2020
10.1007/s12221-020-9507-6


PDF
  Abstract

This study intended for the assessment of the stiffness, tensile and bursting properties of 3D printed auxetic sinusoidal patterns of different density and thickness deposited on the nylon fabric by means of fused deposition modeling (FDM) with the use of thermoplastic polyurethane (TPU) filament. Morphology, weight variation, flex stiffness, tensile property, Poisson셲 ratio and bursting strength were analyzed for the characteristic evaluation of produced composite. The prototypes of two auxetic pattern repeat of 47 mm횞43 mm and 20 mm횞20 mm were developed named as low density (LD) and high density (HD) respectively. Both patterns were repeatedly combined to produce bigger size patterns and 3D printed with various thicknesses. Weight variation is found proportional to the density and thickness of 3D printed auxetic sinusoidal. Maximum up to 552 % weight increase was recorded for LD pattern and for HD 857 %. Flex stiffness increased with the rise of density and thickness of 3D printed auxetic sinusoidal pattern. Maximum flex stiffness for HD was 7.21 cm쨌g and for LD 4.73 cm쨌g. Warp direction is stiffest comparing with diagonal and weft in all cases. In case of tensile strength, a great extent of elongation was noticed due to the presence of auxetic sinusoidal 3D pattern and TPU filament. Maximum, more than 500 % elongation was showed by HD diagonal direction. HD patters exhibited more strength and toughness than LD patterns. In addition, warp direction is strongest and diagonal direction is weakest whereas the weft stays in between. Both LD-1.0 and HD-1.0 3D printed pattern showed negative Poisson셲 ratio and the value was between -1.0 to 0. The enhanced bursting strength is found in HD patterns up to 1514 kPa comparing up to 1449 for LD. Thus, this study confirmed the excellent stiffness, tensile and bursting properties of HD 3D printed auxetic sinusoidal pattern/nylon composite over LD.

  Statistics
Cumulative Counts from November, 2022
Multiple requests among the same browser session are counted as one view. If you mouse over a chart, the values of data points will be shown.


  Cite this article

[IEEE Style]

S. Kabir, H. Kim, S. Lee, "Characterization of 3D Printed Auxetic Sinusoidal Patterns/Nylon Composite Fabrics," Fibers and Polymers, vol. 21, no. 6, pp. 1372-1381, 2020. DOI: 10.1007/s12221-020-9507-6.

[ACM Style]

Shahbaj Kabir, Hyelim Kim, and Sunhee Lee. 2020. Characterization of 3D Printed Auxetic Sinusoidal Patterns/Nylon Composite Fabrics. Fibers and Polymers, 21, 6, (2020), 1372-1381. DOI: 10.1007/s12221-020-9507-6.

Search
(IN TITLE, AUTHOR, ABSTRACT,KEYWORDS)

Advanced Search ▼

POPULAR KEYWORDS
(TOP 10 KEYWORDS)

Recent Publications
(LAST 3 YEARS)

pISSN : 1229 - 9197
eISSN : 1875 - 0052

Impact Factor(2024): 2.3