Evaluation of Tensile Properties of HDPE Geomembranes with Temperature under Exposure to Chemical Solutions 


Vol. 50,  No. 1, pp. 61-67, Feb.  2013
10.12772/TSE.2013.50.061


PDF
  Abstract

In most conventional applications, geosynthetics are exposed to highest mechanical stress during installation. A series of laboratory simulation test for installation damage of geomembrane (GM) was carried out at different loading cycles on HDPE GMs where ISO 10722:2007 was used as a guide. The tensile properties of the samples were tested. The result of the test is reported and it has been found that number of loading cycle has irregular influence on installation damage. It is known that the service life of a GM depends on the exposure conditions, which in a landfill may involve adverse chemical exposure, elevated operating temperatures, and potentially large physical stresses. New equipment was developed and the installation damaged GM samples were exposed to pH solutions under different stress at elevated temperature for hours. Tensile tests was performed to get the residual strength and analyzed. It has been noticed that as the applied stress on GM samples increases, residual tensile strength decreases and they showed higher tolerance to acidic condition than alkali condition.

  Statistics
Cumulative Counts from November, 2022
Multiple requests among the same browser session are counted as one view. If you mouse over a chart, the values of data points will be shown.


Search
(IN TITLE, AUTHOR, ABSTRACT,KEYWORDS)

Advanced Search ▼

POPULAR KEYWORDS
(TOP 10 KEYWORDS)

Recent Publications
(LAST 3 YEARS)

pISSN : 1225 - 1089
eISSN : 2288 - 6419

한국연구재단 우수등재학술지 유지 (2022년)