An Analytical Study on the Change of System Supports according to the Brace Installation 


Vol. 33,  No. 2, pp. 104-111, Apr.  2018
10.14346/JKOSOS.2018.33.2.104


PDF
  Abstract

System supports are widely used in concrete construction due to the convenience and structural safety at the point of both installation and dismantling. However, there were frequent collapses in the construction sites due to the absence of both structural review and brace installations. Therefore, this paper examines the importance of braces in the system supports. In order to examine the importance of the brace, four types of braces were considered: 100% braces, 50% braces, 25% braces, and without braces. The maximum displacement of the 100% braced model was 0.97 mm, the 50% braced model was 1.13 mm, the 25% braced model was 1.16 mm and the non-braced model was 24.3 mm, respectively. Compared to the model with the without-braces, the model with 100% of the braces installed has a displacement of 4.0%, the model with 50% of the braces showed a displacement of 4.7%, and the model with 25% of the braces appeared to be a displacement of 4.8%. That is, the installation of the braces is effective in reducing the maximum displacement of the system supports and is effective in reducing the maximum displacement with only small number of braces installed.

  Statistics
Cumulative Counts from November, 2022
Multiple requests among the same browser session are counted as one view. If you mouse over a chart, the values of data points will be shown.


  Cite this article

[IEEE Style]

오병한 and 최병정, "An Analytical Study on the Change of System Supports according to the Brace Installation," Journal of the Korean Society of Safety, vol. 33, no. 2, pp. 104-111, 2018. DOI: 10.14346/JKOSOS.2018.33.2.104.

[ACM Style]

오병한 and 최병정. 2018. An Analytical Study on the Change of System Supports according to the Brace Installation. Journal of the Korean Society of Safety, 33, 2, (2018), 104-111. DOI: 10.14346/JKOSOS.2018.33.2.104.